SELECTION OF THE BEST SUITABLE MODEL.


Select the correct model for the weight (Mass) of tools or instruments which will be hung. Weight means total weight , that is, tool plus cable hose plus other accesseries. (example)

  1. The weight of tools itself (14 kgs) + the weight of accesories (3 kgs) is equal to 17 Kgs (total weight). so, you should select HSB-22 MODEL (15~22Kgs.)

  2. If the total weight in on the border of two models, you should select the LARGER model. This will benefit you since the balancer will have a longer life.
  • Mount the balancers not to collide with structure.
  • Keep the balancers uneven not to collide with each other.
  • Attach the secondary support cable(or chain) to follow the moving of tools.
  • Adjust the main spring tension to be appropriate to the weight (mass) of tool (or instrument).
  • At Shipping , the main spring tension is set in the middle of its capacity. For increasing, turn the worm clockwise. For decreasing, turn the worm counterclockwise.

TOTAL LOAD - When selecting a balancer, first consideration should be given to the weight of the total load to be balanced (tool plus cable or hose plus other attachments). When the total weight has been determined , the balancer model with the proper tension (weight range) can be chosen. HENDO DELUXE series balancers have an external device for "on-the-job" tension adjustment. The adjustment range for each model is specified in the section tables.

BALANCER MOUNTING - For maximum operator efficiency and balancer life, the tool balancer should always be mounted directly over the work area, with the load perpendicular to the floor when in use. Working with the load not perpendicular causes operator fatigue and excessive wear on balancer cable and drum. when it is necessary to continually move the balancer and tool from one position to another, a system of trolleys and runways can be used.

CABLE TRAVEL - Cable travel is the total length of cable which can be installed in and pulled out of a balancer.

CABLE OVERHANG - Cable overhang is any additional length of cable attached to or part of the active cable, which is not retracted into the balancer. Overhang cable is often necessary for work area with high ceilings.

SECONDARY SUPPORT CHAIN - It is Strongly recommended that all balancers mounted overhead have a secondary support chain attached, to prevent the possibility of the balancer accidentally falling. The chain attaches in the balancer with the other end attached to a support other than the one that supports the balancer. The length of the chain should be kept to an absolute minimum.